|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Analog Breakout
Does the Analog breakout board need additional power when it's in the cRIO?
|
|
#2
|
|||||
|
|||||
|
Re: Analog Breakout
Might want to look at the drawings....
2010_Robot_Power_Distribution_RevA.pdf found here: http://usfirst.org/roboticsprograms/....aspx?id=10934 shows some wires connecting it to power. Also might want to read at least the Robot rules (section 8) http://usfirst.org/roboticsprograms/...nt.aspx?id=452 |
|
#3
|
||||
|
||||
|
Re: Analog Breakout
We ran in to a unique problem - the solenoid breakout board we have is Rev 4 that says "Power 6-20v". So how does one get 24v from this?? I understand Rev 3 says "Power 6-30v", and that would drive the 24v Festo valve just fine. Anyone else have this issue?
Team 3145 |
|
#4
|
||||
|
||||
|
Re: Analog Breakout
Quote:
I would post your concern to FIRST on the official Q&A. Regards, Mike |
|
#5
|
||||
|
||||
|
Re: Analog Breakout
After some time on the phone with various companies, I finally found a very helpful Kate at FIRST. She confirmed that this Rev 4 board is actually mis-marked and should say 6-30v like Rev 3 does. I posted the question on the FIRST forum and it should show up answered soon.
Thought I'd share over here too! Brian |
|
#6
|
|||
|
|||
|
Re: Analog Breakout
Truer words were never spoken.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 80 millivolt sensor on breakout? | skidmarks | FRC Control System | 8 | 13-02-2009 22:38 |
| Wiring a potentiometer to the Analog Breakout | rsisk | Electrical | 6 | 19-01-2009 12:49 |
| Analog Breakout for sale? | DarKCroNo | FRC Control System | 1 | 05-01-2009 16:39 |
| Wiring analog breakout? | excel2474 | Electrical | 5 | 31-12-2008 17:30 |
| 5 Amp Fuses for Analog Breakout & Solenoid Breakout | finman | Electrical | 3 | 10-12-2008 11:59 |