How to properly connect and program servo

Result: 44 volts through the DAP-1522. NOT FUN. - DtD [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
How to properly connect and program servo

Thread Tools

Rate Thread

Display Modes

27-01-2010, 16:04

camper365

Registered User

FRC #1599

Join Date: Feb 2009

Location: Virginia

Posts: 24

camper365 is an unknown quantity at this point

How to properly connect and program servo

We are having problems getting the servo to work. I have tried to find a schematic as to how to connect the servo properly (both power and data) but have had no luck. We might also be having code problems (I don't know for sure) so a method as to how to program the servo would be nice too.
Which call should I use to get and set the angle the servo is at? I think we are using set position now.

__________________
The world only has as much power over you as you let it have.
Linux: Here's the computer, just do stuff.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The Program Compiles and Deploys, but the sidecar doesn't connect	pj174208	Programming	1	14-02-2009 18:26
How to Program a Servo	ExarKun666	C/C++	5	06-02-2009 21:05
How to conect solenoids to the circuit board. and how to program it...???	arpitshah	Pneumatics	6	13-01-2008 15:06
How to set up and run a FF League properly.	Alex Cormier	Fantasy FIRST	4	27-02-2006 17:18

All times are GMT -5. The time now is 11:48.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.