Encoder Codewheel Won't Mount on Shaft

JDM · #1 27-01-2010, 17:18

Hello,

We are having trouble getting one of our encoders installed onto a Toughbox. Normally, the codewheel of the encoder installs on to the shaft well and sort of "clicks" on, however with one of our Toughboxes the codewheel slides on and doesn't stay secure at all. We have tried different wheels that work fine on our other Toughboxes so we are pretty sure it is some kind of problem with the shaft. Does anyone have any idea what this might be, and if we have to get a new shaft from AndyMark, what part it is?

Thanks

Vikesrock · #2 27-01-2010, 17:26

The shaft may have ended up smaller than it is supposed to be preventing the codewheel from being a good tight fit.

The shaft is the output shaft am-0153.

Derschatten · #3 27-01-2010, 17:29

Here http://www.youtube.com/watch?v=4hJfzhxZwKw

watch it at 2:08 it tells you how to fix it.

JDM · #4 27-01-2010, 18:02

Thanks. We did what the video suggested with pliers and it seems to work great, but we also put some glue on just to make sure.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Screwing Encoder into Encoder Mount?	Adrien	Electrical	3	25-01-2009 18:14
How to mount rotary encoder	Logan Williams	Electrical	13	12-01-2009 20:00
pic: Rotary Encoder Mount	Madison	Extra Discussion	8	10-03-2008 21:44
Need Help with Encoder - Won't Count Clicks	Kingofl337	Programming	5	16-02-2005 18:30
shaft encoder help	stephenthe1	Programming	2	03-12-2004 16:09