|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
|||||
|
|||||
|
Re: Connecting Solenoid to CRIO
The double ended female 2-pin cables you found are intended for 2-pin use.
This includes solenoids and the Robot Status Light (RSL). You cut them in half to get two connectors. So take half and wire it to your solenoid wires, then the female end just plugs into the Solenoid Breakout. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| connecting to Crio using windriver | Tds123 | Programming | 1 | 27-01-2010 13:21 |
| Trouble connecting to cRIO? | darty | Programming | 17 | 31-01-2009 16:15 |
| Connecting to the cRIO | lingomaniac88 | Programming | 1 | 30-01-2009 10:58 |
| Connecting Axis camera to cRIO | laultima | FRC Control System | 20 | 21-01-2009 16:56 |
| Connecting Power Distribution block to cRio | Paul Rodi | Electrical | 2 | 05-01-2009 18:20 |