|
|
|
 Realizing your DON'T want to be an engineer is every bit as important as realizing you do - Lil' Lavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Realizing your DON'T want to be an engineer is every bit as important as realizing you do - Lil' Lavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
28-01-2010, 13:34
|
||||
|
||||
|
Re: Electromagnetic gate latch?
[quote=Vikesrock;908225If the electromagnet just holds the part in place, then releases it, with no motion of latch parts then you should be OK.[/QUOTE]
I'd like to see a GDC ruling on this ! Holding is different than actuating. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| electromagnetic solenoid | blnace97 | Rules/Strategy | 9 | 13-01-2010 10:48 |
| pic: Delta field at River Rage - Load In/Out Gate closing the gate | skimoose | Extra Discussion | 4 | 09-11-2009 11:55 |
| 2264 needs some help with a latch. | vivek16 | Technical Discussion | 1 | 29-02-2008 01:52 |
| pic: Carriage Latch Release | Curt Henderson | Extra Discussion | 0 | 24-02-2008 17:09 |
| Electromagnetic solenoids | brandy836 | Electrical | 4 | 24-01-2006 08:26 |
Threaded Mode