|
Re: Programming 24v relay
From the LabView Getting Started screen...look in the Examples section for a solenoid example. Remember, to use the 24v Festo you will have to use a Solenoid module in slot 7 or 8 and connect the power connector to the 24 v supply on the Power Distribution Board. You cannot use a Relay!
__________________
Jon Mittelman
Senior Judge Advisor New England & Israel 2014-2015
Infinite Loop Mentor 2011-2015
TechnoTicks Mentor 2000-2011
Championship Chairman's Award 2009 Team236 TechnoTicks
Judge 2010-2015 Championships
Senior Judge Advisor New England District Championship 2014-2015
Judge Advisor Tel Aviv Regional 2007-2015
Judge Advisor Pine Tree Regional 2013
Maine Regional Planning Committee
New England District Planning Committee
Lead Inspector Microsoft Tel Aviv Regional 2006-2008
Judge & Lead Inspector GM/Technion Tel Aviv Regional 2006
Judge UTC Hartford Regional 2006
|
Is this where I get to say "Mama I made it on TV?" - Pauline Tasci [more] 
28-01-2010, 13:55
Similar Threads
Threaded Mode