|
|
|
 Even when the system is "really good" it can always be tweaked a little to make it even better. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Even when the system is "really good" it can always be tweaked a little to make it even better. - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Jaguars flashing yellow
We cannot get the indicator lights on our jaguars to turn solid. All the indicator lights on our dashboard are green, and all the other lights on our board are behaving normally. We are using the default LabVIEW code on the cRIO and we are relatively sure we have wired the board correctly. When we move the joystick, the driver station shows the bars indicating the PWM ports moving, but a multimeter doesn't detect any electrical current being sent to the motor.
What could be causing our problems? When do the jaguar lights go solid? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jaguars flashing yellow | Ceebs03 | NI LabVIEW | 1 | 28-01-2010 16:18 |
| Yellow Flashing Jaguar/Victor Lights | AlbertW90 | Electrical | 10 | 16-02-2009 11:06 |
| Connecting to cRio, getting the jaguars to go solid yellow.... then nothing. | DSST\neal.ian | FRC Control System | 11 | 30-01-2009 18:15 |
| Jaguars Slow Yellow Blink - Possible Control System Issue | MikeDubreuil | FRC Control System | 3 | 26-01-2009 23:04 |
| flashing LEDs | jacob_dilles | Electrical | 1 | 22-02-2004 21:52 |
Threaded Mode