|
|
|
 However I did tell my wife I wanted to lose 20lbs of ugly fat quickly. She told me to cut off my head. Go figure. - Ed Coleman [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| However I did tell my wife I wanted to lose 20lbs of ugly fat quickly. She told me to cut off my head. Go figure. - Ed Coleman [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Team 3157-needs mecanum wheel in Inventor
|
|
#3
30-01-2010, 00:39
|
||||
|
||||
|
Re: Team 3157-needs mecanum wheel in Inventor
get the toughboxes too, they're better than the autodesk ones, they just require that you slap the CIM on
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mecanum Wheel Setup Help | Dylan5019 | NI LabVIEW | 16 | 10-02-2011 15:39 |
| Mecanum Wheel Considerations | abross | General Forum | 20 | 23-01-2010 19:34 |
| Mecanum wheel size | Mr. A | Technical Discussion | 7 | 18-01-2010 08:58 |
| Mecanum needs a flat floor | Lesman | Technical Discussion | 6 | 16-02-2008 00:45 |
| pic: 2" Mecanum Wheel | Tytus Gerrish | Technical Discussion | 17 | 22-04-2006 12:22 |
Hybrid Mode
