|
|
|
 Adding an ounce or two of shields is way easier than filling out the mountains of paperwork for that one impatient person to stick their arm into the robot reaching for who knows what only to have their fingers meet up close and personal with a gearbox. - artdutra04 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
30-01-2010, 18:17
|
||||
|
||||
|
Re: CNC / TIG Welding Problems
Are you doing AC tig welding? That's usually the culprit... see if you have a high-frequency adjustment on the welder and turn it down. Or try welding with a "soft" AC arc, not a square wave of anything fancy. It's the high-frequency waves used to make square and triangle welding waveforms that screw up electronics.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EMC linux + CNC mill + CNC Lathe | Leav | Technical Discussion | 8 | 09-11-2008 23:08 |
| TIG Welding Problems | cobrawanabe1699 | Technical Discussion | 21 | 03-11-2008 13:51 |
| Intelitek CNC Motion - Virtual CNC Machines | Kingofl337 | Programming | 0 | 19-03-2008 11:29 |
| Welding Aluminum MIG or TIG? | Arkorobotics | Technical Discussion | 15 | 01-02-2007 13:17 |
| SCRRF - TIG Welder | Redhead Jokes | Southern California Regional Robotics Forum | 4 | 10-01-2003 13:11 |
Threaded Mode