|
|
|
 Representing data in a good way is an art in its own right. - Andrew Schreiber [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Representing data in a good way is an art in its own right. - Andrew Schreiber [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
30-01-2010, 18:27
|
||||
|
||||
|
Re: Changing IP & Default Code
In Netbeans, you have to click on "New Project", not "Load Project", in order to see the DefaultCodeProject.
To set the team number, click on Tools->Options->Miscellaneous. There is a box for the team number on the FRC Configuration tab. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Changing Default Unit System | Richard McClellan | SolidWorks | 6 | 28-02-2010 16:09 |
| Camera & Default Code | Lablabla | Programming | 14 | 28-01-2007 18:25 |
| Problems when combine ADC code && camera code | nirhaim1942 | Programming | 1 | 24-01-2007 06:58 |
| Victors, Default code, & joystick configuration | Vermatitis | Control System | 4 | 27-01-2005 16:01 |
| Victors, Default code, & joystick configuration | Vermatitis | Electrical | 4 | 27-01-2005 16:01 |
Threaded Mode