|
|
|
 I think Dave has been spending time on icanhascheezburger. Either that or the fumes from his rendering machines have affected the grammar control portion of his brain. - rsisk [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
01-31-2010, 02:17 AM
|
|||
|
|||
|
Re: help with the I/O
There is a hex file in the Shared Documents folder that needs to be programmed onto the PSoC board.
However unless you plan on wiring up a custom control panel you don't need to worry about the Cypress I/O module. Most teams only use Joysticks and don't need the I/O and can therefore safely ignore that message. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can any one help us with programing the encoder to control the motor by ticks? | Must Be Drama | NI LabVIEW | 4 | 02-09-2009 08:54 PM |
| HELP!!! STUCK WITH SUB ROUTINES WITH THE IR!!! | drewjones13 | Programming | 1 | 01-17-2008 08:52 PM |
| need help with the ir | tinderfitles | Programming | 3 | 02-03-2004 03:31 PM |
| Help with the storyboard. | LizJJury | 3D Animation and Competition | 11 | 01-13-2003 08:37 AM |
| Please help me with the size of the rotating light!!! | bigqueue | Technical Discussion | 5 | 01-21-2002 09:40 AM |
Threaded Mode