|
|
|
 Anyone else think we're (including me) a little obsessed? The seasons over and were already onto the next one. - Bjenks548 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Anyone else think we're (including me) a little obsessed? The seasons over and were already onto the next one. - Bjenks548 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
31-01-2010, 15:45
|
|||||
|
|||||
|
Re: Troubleshooting solenoid breakout
If the 8 status indicators on the cRIO module itself are not lighting up, then the problem is before the Solenoid Breakout.
I assume the Driver Station Diagnostic tab status is all good? The RSL is doing it's long on, short off sequence? Then it's a LabVIEW coding problem. Is the compressor code working? P.S. Good error reporting by-the-way! Last edited by Mark McLeod : 31-01-2010 at 15:48. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solenoid not firing off Solenoid Breakout | spooncwru | Pneumatics | 2 | 30-01-2010 17:46 |
| 5 Amp Fuses for Analog Breakout & Solenoid Breakout | finman | Electrical | 3 | 10-12-2008 11:59 |
| PID Troubleshooting | Disar | Programming | 4 | 13-09-2006 15:27 |
| Troubleshooting - 783 | lee87 | Website Design/Showcase | 2 | 13-02-2005 20:15 |
| Troubleshooting System | SilverStar | Technical Discussion | 0 | 23-01-2004 21:22 |
Threaded Mode