|
|
|
 One of my management professors taught me this: At all times you are holding a bucket in each hand, one full of water, and one full of gasoline. Management is knowing when to throw which bucket. - Barry Bonzack [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
KOP Mangetic Encoders Don't Spin Full 360
Hello, today I was using the KOP magnetic encoders in analog mode. To my understanding, It should read 0 volts at 0 degrees, and 5 volts at 360 degrees, and vary linearly in between. However, It seems that they reach 5 volts at about 270 degrees, and reset after that. This is true for both the encoders in the kit. Perhaps the magnet is not properly centered on the chip? If so, it is strange that they are both reseting at a similar angle. Has anyone else experienced this? Thanks for any help.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attaching KoP encoders | DarKCroNo | Electrical | 4 | 04-02-2009 17:23 |
| KoP Quadrature Encoders | ComradeNikolai | Sensors | 1 | 22-01-2009 14:22 |
| 2009 KoP Wheel broken (already) - don't drop them! | DonRotolo | Kit & Additional Hardware | 2 | 17-01-2009 13:12 |
| Don't Do What Seanny Don't Does | Mike Iantorno | General Forum | 38 | 05-02-2003 23:56 |
Threaded Mode