"watchdog not fed" error

[Shivang1923]

We had the same error in the begining of build season.

What I noticed was that the camera has a watchdog.feed vi. Without communications to the camera, even the default code was getting all confused. Have you set up your camera properly and is it on and connected to the cRIO properly?

It fixed our watchdog problem

[Lumit]

Turns out that our issue was that we tried to run the code by deploying it directly from labview without setting it to run as startup.

It's working perfectly now.

thanks for the replies

[BLProgram2010]

We're having the same problem with the Watchdog, but we ran the code as a startup and the watchdog still pervent the robot from responding to the joysticks. we as install all the updates and do have that compass on our dashboard. But every time we enable the robot we recieve a watchdog not feed message. Please help us

[Mark McLeod]

Does this happen if you try using a new default Robot Project?

Do you have "Teleoperated" clicked on the Driver Station before you Enable?

[hamosad1657]

This error can appear because only 1 reason: You trying to download a code that wrote with previous LabVIEW version, to a cRIO with Image of newer version. BUT! When you met that error while the cRIO Image is compatible to the code version, the single solution is to reset the cRIO through the Diagnostic panel in the Driver Station.