2010 Accelerometer I2C Object/Class

jhersh · #1 01-02-2010, 16:48

Quote:

Originally Posted by charrisTTI

Note, the sparkfun board is 3.3V not 5.0V so you need to order their bidirectional level converter and 3.3V regulator to make it work.

From the sparkfun website:

Quote:

Originally Posted by SparkFun

The ADXL320 can be powered from 2.4V-5.25V.

Surely they aren't just giving irrelevant information.

charrisTTI · #2 01-02-2010, 17:40

Quote:

Originally Posted by jhersh

From the sparkfun website:

Surely they aren't just giving irrelevant information.

Sorry for the confusion. The ADXL345 (same as this year KOP) from sparkfun is 3.3V.

NerdGuy · #3 01-02-2010, 23:49

RAWR!!!

thanks alot for help.

I will try the above I2C class, looks better than ours.
but then again ours was coded on a hope and a prayer seeing that we did not understand any of that low level stuff.

thanks again.

Also thanks for the analog accel link.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with 2010 Accelerometer & I2C	wt200999	C/C++	33	08-02-2010 15:16
2010 accelerometer	chsr	C/C++	1	22-01-2010 02:28
2010 Accelerometer Documentation?	JDM	Sensors	13	18-01-2010 12:42
Where to find a Gyro and Accelerometer Sensor Board for 2010 FRC?	xSpongeX	Sensors	4	18-01-2010 06:17
Accelerometer class - isn't reading zero at rest?	oddjob	C/C++	3	02-02-2009 17:11