|
|
|
 So the bar is set insanely high. Probably unachievably high for some of us. But what a shame it would be to lower it. - pfreivald [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| So the bar is set insanely high. Probably unachievably high for some of us. But what a shame it would be to lower it. - pfreivald [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
[FTC]: Questions From a New Team
Hello, this is the Francis Lewis robotics team and it is out first year participating in FTC. Our FTC group consists of about 10 members, and we are not sure about a few things.
1 Are there any other forums/resources for FTC that are active? 2. FRC had a lot of freedom to manufacture parts out of anything that was not prohibitively expensive. FTC has many restrictions and we are not sure about the following: a) We want to put a curve ramp similar to a snow plow blade. What material is needed to build it and how do you suggest we build it? b) How can we extend the frame, specifically the base of the robot? We wanted to extend the robot's frame after the match starts in order to increase the ball capacity. Thank you in advance for your time. -FLHS 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Questions about first time at FTC World Championship | Madison | FIRST Tech Challenge | 19 | 17-12-2009 17:25 |
| [FTC]: How do you find new FTC team members? | NalaTI | FIRST Tech Challenge | 3 | 26-07-2009 10:50 |
| [FTC]: Starting a New FTC Team | addictedMax | FIRST Tech Challenge | 11 | 20-08-2008 10:32 |
| New member, new team, questions. | Frank(Aflak) | General Forum | 21 | 14-12-2002 06:59 |
| Questions from a first time team | Sparky | Championship Event | 6 | 18-03-2002 16:58 |
Threaded Mode