PSoC still not recognized

Adamsmasher23 · #1 01-02-2010, 20:17

Hi all,

I have programmed the PSoC as per the instructions, and I have uninstalled and reinstalled the DS updates several times.

But, the I/O unit is still not being recognized. The messages box says 'I/O unit not detected or not installed correctly.'

Any suggestions>

miniman · #2 01-02-2010, 20:26

we had the same problem. I wasn't the one to fix it, but i believe that they first tried to get the PSoC Programmer to recognize it. Once they did that it began to work like it should, recognizing every time.

Alan Anderson · #3 01-02-2010, 20:51

How exactly do you have it connected? Perhaps the "not installed correctly" part of the message is the relevant one.

bls0620 · #4 01-02-2010, 22:11

Does your driver station have a compass(gyro) and four graphs? If you don't you'll have to uninstall driver station update and reapply it.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[BB]: Still not Bill	EricH	General Forum	14	03-12-2009 12:31
Activation of LabView still not working	apollorest	National Instruments LabVIEW and Data Acquisition	4	22-11-2008 21:09
Week 6 and still not finished!	Phil Paspalas	General Forum	61	19-02-2006 17:10
IR Beacon/reciever not working... still...	Ferazel2001	Programming	23	04-02-2004 23:30
EDU RC not being recognized...	Caleb Fulton	Programming	5	24-03-2003 09:29