|
|
|
 Those poor suckers on the West coast get three hours LESS sleep than we do afterward. Anyone else glad to see that crate go every year, regardless of what's in it? - Rich Kressly [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Invariant FPGA Image Version Error?
Wow. This one really stumps me. It reports a version error even though it is clearly able to deploy the image and even print the matching version (the "hardware" GUID, version, and revision). I looked closely at the code that generates this messaage, and it is caused by not being able to open the handle to the FPGA image after it is downloaded. I'll have to get back to you on this one.
-Joe 
|
|
#2
03-02-2010, 02:51
|
|||
|
|||
|
Re: Invariant FPGA Image Version Error?
Hi,
I'd like you to replace the attached file (unzipped, of course) on your cRIO and reboot your controller, capturing the boot messages just like you did before. It goes in "/ni-rt/system/". I added a few prints that will hopefully point to what is going on. Thanks, -Joe
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error "IFI>Master Code Version: 8 " | mecanumbot | Programming | 0 | 24-01-2010 01:30 |
| cRIO Image version? | Chris11246 | Programming | 1 | 14-02-2009 16:44 |
| v11 cRIO Image Error | Team1710 | Programming | 7 | 14-02-2009 12:56 |
| FPGA Image | idahorobot | FRC Control System | 1 | 12-02-2009 01:23 |
| Error in Compiling the Camera Code (B&W Version) | VetteSlick | Programming | 7 | 20-01-2006 20:50 |
Hybrid Mode
