|
|
|
 Curse those filthy wrench-swinging rivet-popping screw-driving hammer-smashing mechanical barbarians. Hand over the robot to the programmers! - cjl2625 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Curse those filthy wrench-swinging rivet-popping screw-driving hammer-smashing mechanical barbarians. Hand over the robot to the programmers! - cjl2625 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
03-02-2010, 19:19
|
||||
|
||||
|
Re: "watchdog not fed" error
We're having the same problem with the Watchdog, but we ran the code as a startup and the watchdog still pervent the robot from responding to the joysticks. we as install all the updates and do have that compass on our dashboard. But every time we enable the robot we recieve a watchdog not feed message.
 Please help us 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Watchdog not fed | ahudson | Programming | 1 | 22-01-2010 11:26 |
| MPLAB 8.0 error "Can not fit section" | billbo911 | Programming | 7 | 20-02-2008 15:26 |
| "Demo Stamp not found" error message | Gatto | Programming | 1 | 07-02-2007 23:17 |
| Screenshot of "code not understood" or similar error needed! | Elgin Clock | Programming | 3 | 17-02-2006 22:06 |
| Program error - "can not fit the section" | miketwalker | Programming | 9 | 20-02-2005 01:21 |
Threaded Mode