|
|
|
 do i even have to say anything about hurricane jeanne after my comments about charley, frances and ivan? :mad: but if i could, i would run all of them over with my robot... - Arefin Bari [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
03-02-2010, 23:24
|
|||||
|
|||||
|
Re: Utlizing the Driver Station to Assist Autonomous Mode
Switches or similar sensors either on the robot or on the driver station (value read during autonomous disabled and stored) are common ways to have multiple autonomous modes.
Before the match set the switches for the appropriate mode and you're all set. You will be able to have 2^(N) modes where N is the number of switches used. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver Station for Autonomous | shrimp | Control System | 5 | 03-03-2009 17:05 |
| Driver station communication during autonomous | drosophyllum | Control System | 1 | 23-02-2009 21:39 |
| paper: Set and display your Auto-Mode using LabVIEW and the Driver Station | PhilBot | Extra Discussion | 0 | 11-02-2009 12:32 |
| Updating the Driver Station | PHSRobotics | FRC Control System | 1 | 25-01-2009 19:11 |
| Mounting the Driver Station...? | 1708xMr.Roboto | FRC Control System | 1 | 15-12-2008 12:34 |
Threaded Mode