|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
||||
|
||||
|
Re: [FTC]: Robot problems with motor movment
Are encoders mounted on the motors?
If yes, are they wired correctly? Are they coded correctly? If using ROBOTC, are the encoders correctly setup in the Motor Controller settings? If no, and using ROBOTC, verify that the encoders are not selected in the Motor Controller settings. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: [FTC]: Motor Problems | fqzeng | FIRST Tech Challenge | 3 | 16-02-2009 19:12 |
| [FTC]: Problems with Motor Encoders? | FTC 2891 | FIRST Tech Challenge | 2 | 16-02-2009 19:03 |
| [FTC]: Random Error with FTC motor control | Xaphiinia | FIRST Tech Challenge | 2 | 01-12-2008 15:39 |
| [FTC]: FTC Servo-Motor Problem with Labview | dnhansen | FIRST Tech Challenge | 1 | 26-10-2008 00:43 |
| [FTC]: [FTC] Motor Controller problems | michael714 | FIRST Tech Challenge | 4 | 14-10-2008 00:33 |