Bending Tubes in Inventor

If it were not about winning, it would not be called a competition - but FRC is much more than winning a competition. - JaneYoung [more]

		Chief Delphi > Technical > CAD > Inventor
Bending Tubes in Inventor

Thread Tools

Rate Thread

Display Modes

04-02-2010, 21:51

MGoelz

Miranda: Design and Scouting

FRC #0234 (Cyber Blue)

Team Role: Alumni

Join Date: Jan 2007

Rookie Year: 2005

Location: Indianapolis, IN

Posts: 166

Bending Tubes in Inventor

Our team was trying to figure out how to bend tubes or pipes in Inventor and couldn't find any adequate tutorials or anything, and we didn't see any older threads about it either. If someone could direct us to a good tutorial or can briefly explain how to go about bending a tube, it would be greatly appreciated.

Thanks

__________________
"The ideal engineer is a composite ... He is not a scientist, he is not a mathematician, he is not a sociologist or a writer; but he may use the knowledge and techniques of any or all of these disciplines in solving engineering problems."
— N. W. Dougherty

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bending the Bumpers	BeyondRamo	General Forum	7	12-02-2008 18:39
Bending Aluminum Tubing?	Kims Robot	Technical Discussion	11	08-02-2008 03:53
Bending Metal	Jeremiah Johnson	FIRST Tech Challenge	2	01-05-2006 01:15
bending bumpers	CharlieWilken	Technical Discussion	3	19-01-2006 10:02
bending parts	foobert	FIRST Tech Challenge	4	15-01-2006 13:17

All times are GMT -5. The time now is 01:38.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.