|
Re: Bending Tubes in Inventor
Quote:
Originally Posted by MGoelz
Our team was trying to figure out how to bend tubes or pipes in Inventor and couldn't find any adequate tutorials or anything, and we didn't see any older threads about it either. If someone could direct us to a good tutorial or can briefly explain how to go about bending a tube, it would be greatly appreciated.
Thanks
|
There are a whole bunch of tutorials on here, I'm not sure exactly what your thinking of, but to me it sounds like you can accomplish what you need by using the sweep feature.
http://mfgcommunity.autodesk.com/learning/tutorials/
__________________
2010
Team 2228(FRC) - Drive Team Lead, Drive Coach, Mechanical Team
Team 3750(FTC) - Team Lead
2009
Team 2228(FRC) - Mechanical Team, Driver at RIT, and Hartford Regionals, and Drive coach at Ruckus
*Second Place at Ruckus
Team 3750(FTC) - Team Lead, and Drive coach at Clarkson Regional
*Second Place at Clarkson Regional
2008
Team 1930(FRC) - Worked on Mechanical, Electrical, and Programming.
|
Maybe FRC WILL casue world peace, who knows, eh ? - Tottanka [more] 
04-02-2010, 22:34
Similar Threads
Threaded Mode