|
|
|
 Don't over analyze every possibility. Studying a problem too much doesn't help any more than not studying it enough. - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't over analyze every possibility. Studying a problem too much doesn't help any more than not studying it enough. - dlavery [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
AXIS CAMERA HARDWARE SETUP
I'm not sure about this, however I'm wondering is the camera setup DIFFERENT from last year? We are using the same setup, which is using the SERVO motors. I'm wondering are we suppose to use that again? because in the program it talks about using a gyro and no values concerning the PWM connectors where the servos went. So if it HAS changed, I'm wondering how its set up? Do we juts mount the camera and place a gyro on the robot itself?
|
|
#2
04-02-2010, 23:31
|
|||||
|
|||||
|
Re: AXIS CAMERA HARDWARE SETUP
In LabVIEW, at least, the provided code for this year runs the drive motors to spin the entire robot. It uses the camera to determine how far to turn, then uses the gyro to know when it has turned that much. The camera seems assumed to be mounted to the robot in a fixed location.
|
|
#3
04-02-2010, 23:35
|
||||
|
||||
|
Re: AXIS CAMERA HARDWARE SETUP
Ohh i see, thank you!
Would you be able to provide help on another thread I've posted? it's about programming in C++ http://www.chiefdelphi.com/forums/sh...ad.php?t=81922 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Java/Netbeans Camera Code for Classmate PC and Axis Camera | joshholat | Programming | 1 | 23-01-2010 14:59 |
| Help: "Setup Axis Camera" | sloteera | Programming | 9 | 16-01-2010 00:59 |
| Camera Setup | ExarKun666 | Control System | 10 | 25-02-2009 19:18 |
| Can't figure out the Axis camera setup... | 2829ron | Technical Discussion | 6 | 20-01-2009 13:12 |
| Setup Axis Camera - ERROR | Bruno Inácio | Technical Discussion | 2 | 16-01-2009 12:37 |
Linear Mode
