PSoC Build error

[norm365]

If we do not need to program the PSoC to use the Advanced I/O functions, where do we find the pin assignments for the I/O: AO,AI,DO,DI ? I plugged in the PSoC and on the error log of the driver station it said it was either not plugged in properly or not programmed.

[Mike Betts]

Originally Posted by norm365

If we do not need to program the PSoC to use the Advanced I/O functions, where do we find the pin assignments for the I/O: AO,AI,DO,DI ? ...

Is this what you are looking for?

[Vikesrock]

Originally Posted by norm365

If we do not need to program the PSoC to use the Advanced I/O functions, where do we find the pin assignments for the I/O: AO,AI,DO,DI ? I plugged in the PSoC and on the error log of the driver station it said it was either not plugged in properly or not programmed.

You do still have to program it with the provided FIRST hex file as detailed towards the end of Chapter 2 of the Control System Manual.

Also, I remember seeing some teams mentioning that some uninstalling and reinstalling of the Driver Station Update and/or the Cypress software managed to fix issues with the PSoC not being recognized by the Classmate.

On the I/O tab of the Driver Station there is a Configure button that will allow you to setup some parameters of the PSoC if desired.

[norm365]

That is exactly what I was looking for. Thank you Mike & Kevin. Once we dig out of 18" of snow, we will make it to the robot to try it out!!

Norm