|
|
|
 A wet noodle of a chassis won't matter how much drop you have. - Andrew Schreiber [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| A wet noodle of a chassis won't matter how much drop you have. - Andrew Schreiber [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Servos won't work
Hello,
We are a rookie team just learning LabVIEW. We have been able to get our robot moving, but we are having problem with servos. I am attaching a copy of our program. I have tried changing the configurations on the motor configurations page but nothing has worked. I've also tried changing the channels that the servos are connected to. I tried moving the servo controller up in our daisy chain but then our motors wouldn't work. I am pretty positive that our wiring is right, but I could be wrong. If someone could take a look at the program and maybe give me some suggestions to make sure that my wiring is correct I would be extremely grateful. Thanks Hampton 
|
|
#3
07-02-2010, 15:28
|
|||
|
|||
|
Re: Servos won't work
did you also put the Jumpers on the PWM terminals that have servos>>>>
cause if not they wont work even if the program is correct
|
|
#4
07-02-2010, 15:58
|
|||
|
|||
|
Re: Servos won't work
What jumpers? What do they look like? Where do I attach them? This is all new to me so I have no idea what you are talking about. I will also post this in the FTC forum. Thanks
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gyro won't work right =? | DtD | C/C++ | 4 | 15-02-2009 10:57 |
| chicklet won't work | bsbllpss | Control System | 3 | 05-02-2008 09:33 |
| Warcraft won't work, don't knwo why | John Gutmann | Chit-Chat | 2 | 27-07-2007 08:52 |
| Servos don't work | jpflorido | Programming | 4 | 06-05-2006 06:34 |
| 3D Studio Max won't work | David the bomb | 3D Animation and Competition | 3 | 03-03-2004 17:12 |
Linear Mode
