|
|
|
 The flux capacitor should have been allowed under the flowchart as long as it met the single component maximum cost. I did check with Digikey and they no longer carry the line. - Al Skierkiewicz [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Compressor not working.
Our compressor seems to not be functioning properly. If we just apply a power source straight to the compressor it functions fine. We checked the programming and it seems fine. (Begin: Open Compressor(DIO-1, Relay-1)->Start->Devref) When we try to run the code on the robot and then enable it, the compressor fails to run each time. We tried to replace the Spike attached to the relay and compressor but nothing happened.
Any help with setting up the compressor? Thanks a lot!  |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compressor NOT Working (multiple trials already) | Noel | Pneumatics | 10 | 02-02-2009 18:38 |
| p2 not working? | Lone_Wolf92c | Programming | 5 | 22-02-2008 08:49 |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| cam not working :( | magical hands | Programming | 3 | 05-02-2005 21:45 |
| Radios not working... | E Jones 234 | Electrical | 3 | 21-01-2005 21:58 |
Threaded Mode