Need some Labview help!

[Bill Taylor]

I am the primary programmer for our team this year and as far as programming goes I have about a 3rd grader level of expertise. I take that back...my 3 yr old son could probably do better than i am doing. My question is... I am using the out-of-box labview FRC project wizard and switched drive to arcade using 4 motors. This is working fine with no hangups. i want to be able to turn one of those 4 motors (ex.motor #1) on using a joystick button (ex.button#8) independently. essentially, when the robot's arcade drive is parked and the operator is off the stick, push a button to run a single drive motor by itself. if someone could tell me how i might do this it would be appreciated. please be specific or show me a wired diagram as i am apt to miss a step. thanks.