|
|
|
 We're basically using a two step process: 1. Smoke 2. Mirrors - Tom Bottiglieri [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We're basically using a two step process: 1. Smoke 2. Mirrors - Tom Bottiglieri [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
problems with using switches for autonomous
For our team autonomous, we decided to use switches for autonomous. We connected the Cypress board and the breadboard to wire up the switches. The value from the switches are being displayed on the driver station(classmate) but somehow, the program is not reading the value. The only value that it reads is 0. Even when we flip the switches, the value on the laptop does not change. (However, the value on the driver station is changing without any problems.)
Could anyone please help us on this problem?  Thank you!  EDIT* The values from the switches are being read by the Classmate Driver Station, but not on the programming laptop (separate from the Classmate). It shows change on the Classmate Driver Station, but not on the programming laptop. Last edited by ssica_jj : 07-02-2010 at 22:56. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming toggle switches to DS for different autonomous routines? | grosh | NI LabVIEW | 9 | 30-03-2009 20:42 |
| Problems with using 330's goal tracking code | windell747 | NI LabVIEW | 11 | 16-02-2009 13:02 |
| Using Limit Switches with the Arm | iwin2000 | Programming | 3 | 18-02-2008 03:52 |
| Problems with transmission using Inventor 8 | Drew Hopman | Inventor | 4 | 10-01-2005 19:07 |
| laser radar with BS2p using RS232 problems... | chei_UCF19 | Programming | 6 | 26-02-2004 15:21 |
Threaded Mode