|
|
|
 We make ourselves better by lifting others and standing on their shoulders, not by knocking them down. - Taylor [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We make ourselves better by lifting others and standing on their shoulders, not by knocking them down. - Taylor [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
08-02-2010, 07:00
|
|||||
|
|||||
|
Re: pic: 1747- Kicker Winch
It is a modified toughbox, containing only a 14 tooth CIM gear (attached to the window motor) and a 50 tooth output gear. The cylinder disengages the gear, allowing a 6" IFI wheel attached to the output shaft (not shown) to spin freely.
We added more structure than what you seen in this picture to prevent the bottom plate from bending when the cylinder extends. We will probably increase the cylinder bore size to 2", since the current one cannot hold the load we desire. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Winch for Kicker | MrForbes | Extra Discussion | 10 | 10-02-2010 10:42 |
| pic: 1747 Teaser | 1747robotics | Extra Discussion | 3 | 07-02-2010 23:57 |
| pic: Buckeye: 1747 Panda Pose | Dan 1038 | Extra Discussion | 9 | 03-03-2009 17:23 |
| pic: 1747 Turret Close up | Allison | Robot Showcase | 2 | 20-02-2007 10:16 |
| pic: Vex Winch | AdamHeard | Extra Discussion | 5 | 16-11-2006 23:30 |
Threaded Mode