|
|
|
 If I am going to give away six dozens tasty treats without allowing any for myself, I have to make sure that the challenge is really worth it! - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If I am going to give away six dozens tasty treats without allowing any for myself, I have to make sure that the challenge is really worth it! - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
08-02-2010, 18:17
|
|||||
|
|||||
|
Re: Voltage not outputting to the Drivers Station
What is the NI number on the Module you have in slot 1?
From your photo it looks like you have the Analog Breakout board mounted on the Solenoid Module (NI 9472) (it has 8 little green LEDs on it), instead of the Analog Module (NI 9201) (no LEDs). P.S. I can't see your photo at work or school the way you attached it. I only happened to see it while browsing from home. Otherwise, I would have mentioned it sooner. Last edited by Mark McLeod : 09-02-2010 at 10:49. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver Station not displaying Battery Voltage | Doc Wu | FRC Control System | 7 | 23-02-2010 16:03 |
| Drivers station problems | Chris11246 | Programming | 7 | 16-02-2009 19:36 |
| Drivers Station Magical Current | 3DWolf | Electrical | 5 | 25-01-2009 21:52 |
| Telling the drivers station your alliance | Mike Mahar | Technical Discussion | 2 | 17-01-2009 12:24 |
| PWMs not outputting in Autonomous | 937Programmers | Programming | 15 | 08-02-2007 21:25 |
Threaded Mode