|
|
|
 You know how grandmothers get shirts that say "Ask me about my grandchildren"? I want one that says "Ask me about my robotics team." - MissInformation [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You know how grandmothers get shirts that say "Ask me about my grandchildren"? I want one that says "Ask me about my robotics team." - MissInformation [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
LabVIEW/Jaguar Help
The Software has been updated. The cRIO has been updated. The instructions were followed to the letter for implementing Simple Motor Control. The program compiles and downloads without an error. Under the "Watch Mode" everything functions without an error. However, the Joystick does not cause the motor to run and the Jaguar flashes yellow (never going solid).
All of the wires have been tested for continuity. All parts have been systematically swapped out. Does anyone have any suggestions/help as to why the Jaguar never goes solid and the motor doesn't turn? We can't go any further until we resolve this issue. bhenze@sapulpaps.org |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| labview delay help | glitch | NI LabVIEW | 3 | 08-02-2010 09:37 |
| Labview help | pedro696 | General Forum | 14 | 06-02-2010 19:34 |
| HELP!!!! we need help w/ compressors/pneumatics for teleop/autonomous in LABVIEW | rokenboker | NI LabVIEW | 9 | 05-02-2010 17:10 |
| labview comressor help!! | mole | NI LabVIEW | 15 | 03-02-2009 14:11 |
| help: cannot get the picture in the labVIEW program .. (was: need help!! quickly!) | liad | LabView and Data Acquisition | 8 | 18-01-2006 12:20 |
Threaded Mode