|
|
|
 Yes, a big part of FIRST is learning from others. But a just as important part of FIRST is learning from discovery. - [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Yes, a big part of FIRST is learning from others. But a just as important part of FIRST is learning from discovery. - [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
rack and pinion problem
a rack and pinion is used to drive a gate mechanism. The pinion has module of 12, 11 teeth and a pressure angle of 25. Solve for the details for each gear profiles.
 Shaft diameter = 30 mm Hub diameter = 60 mm Keyway = 8x8 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rack and Pinion Drive? | bmarick | Technical Discussion | 2 | 06-01-2009 22:16 |
| Rack and Pinion | DarkFlame145 | Technical Discussion | 0 | 02-04-2008 20:30 |
| Rack and Pinion/Motors and servos | psniffler | Motors | 7 | 25-01-2008 16:16 |
| Rack & Pinion | SHS Blue Devils | General Forum | 5 | 12-01-2008 17:59 |
| rack and pinion. | greencactus3 | Pneumatics | 17 | 04-11-2004 23:24 |
Linear Mode
