trouble undeploying default or downloaded code

stevethetinker · #1 07-02-2010, 00:33

I need to do some debugging and I am unable to get the downloaded code, whether default or mine, to undeploy. I get the following message when I try:

Unable to delete the UserProgram from the robot

The odd part is this used to work (famous last words). I had some trouble from downloading (FIRST->Download) a program that did not clean up its tasks and I had to re-image the cRIO. Since then I've had odd problems.

I found some posts on this from last year but they are not helpful. Has anyone encountered this problem this year?

apalrd · #2 07-02-2010, 11:54

Deploying a new program should overwrite the old one. Thus you should never need to undeploy code.

stevethetinker · #3 07-02-2010, 17:40

In order to debug a kernel task, the instructions say to undeploy the existing code because somehow it interferes with the debugger. I need to run the debugger. Ergo, I need to undeploy the downloaded code.

stevethetinker · #4 09-02-2010, 15:01

The problem has gone away. I eventually deployed some code and after that I could undeploy. Don't know what it was.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Code downloaded but not working... :(	pudgeball	C/C++	4	28-01-2010 11:04
Undeploying code. NEED HELP	dnrobotics11	C/C++	3	01-02-2009 18:33
i downloaded the source code, now what do i do?	programmr	Programming	2	12-12-2008 14:39
Problems integrating CMUCAM code and IFI Default Code	Windward	Programming	2	06-02-2007 16:48
problems using gyro/adc code with camera default code	tanstaafl	Programming	7	22-01-2006 23:09