|
|
|
 When was the last time you heard of someone on their death bed talking about a great movie they saw? I think it far more likely to hear of their accomplishments, something they did to make things better. Well that's what FIRST is all about. - DougHogg [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
10-02-2010, 00:25
|
|||||
|
|||||
|
Re: Piston extends but does not retract?
If you're just trying to get the Solenoid Module LEDs to light, then it's a code problem, not a wiring problem. Those are independent of the wiring that occurs afterwards in the Solenoid bumper and the solenoid itself. You can pull off the Solenoid Breakout and that will not affect the code's ability to turn the LEDs on and off.
Usually, I wouldn't program to have both sides of a solenoid off at the same time, but that doesn't concern what you're seeing in the LEDs. Last edited by Mark McLeod : 10-02-2010 at 00:27. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Code deploys but does not save to cRIO | Bill Taylor | NI LabVIEW | 11 | 15-02-2012 20:30 |
| Can't retract to go under TUNNEL? | Racer26 | General Forum | 31 | 28-01-2010 09:51 |
| URGENT HELP: IR board TRAINS but does not RECIEVE | dan_h | Sensors | 6 | 20-02-2008 20:31 |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| frc_camera not working but labview does | Issues | Programming | 7 | 18-01-2006 19:23 |
Threaded Mode