|
|
|
 DO NOT THROW THINGS AT THE PROGRAMMER! - demosthenes2k8 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| DO NOT THROW THINGS AT THE PROGRAMMER! - demosthenes2k8 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
trouble with the holonomic drive
Hello everyone,
Me and my team decided to use mecanum wheels for our robot. We programmed the robot to drive backwards,forward,left and right. Now the driver wants us to program the robot to rotate around it self using the z axis (we bought a special joystick): http://www.logitech.com/index.cfm/ga...s/291&cl=us,en We're not quite sure how to do it and we would really aprecciate help  attached what we've done with the holonimic so far Thanks everyone 
|
|
#2
08-02-2010, 18:51
|
||||
|
||||
|
Re: trouble with the holonomic drive
Haven't done this before, but try reading the 3rd axis (1 is usually X axis, 2 is usually Y).
--Ryan
|
|
#3
10-02-2010, 20:29
|
||||
|
||||
|
Re: trouble with the holonomic drive
instantiate each of your motors independently and set values with the motor's "Set Speed" icon. This would completely eliminate the Holonomic drive issue, because you would take it's place with setting and instantiating each motor.
Respond if you did/did not understand
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using holonomic Drive with Dual Joystick Controller | robotic321 | NI LabVIEW | 2 | 05-02-2010 23:45 |
| Holonomic drive angle? | dwodrich | NI LabVIEW | 17 | 05-02-2010 09:39 |
| How do you wire the inputs for holonomic drive (omni wheels) | star_lancer | NI LabVIEW | 8 | 22-01-2010 22:29 |
| Switching to Holonomic Drive | MachineSMMC | NI LabVIEW | 1 | 22-01-2010 13:07 |
| Holonomic drive vi with mecanum wheels | dwodrich | NI LabVIEW | 7 | 18-01-2010 16:01 |
Linear Mode
