|
|
|
 If this information is not 100% correct, you should follow the default advice I have for when anything goes wrong: Blame the Programmers - IKE [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If this information is not 100% correct, you should follow the default advice I have for when anything goes wrong: Blame the Programmers - IKE [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Is knocking the guts out of a motor a commutative event?
Well... after much frustration, my team managed to use team 1334's arbor press to get the pinion gears off our FP motors. These luckily happened to be the required 15-tooth sun gears required for our AM planetary transmission, especially because our didn't ship with the sun gear it was supposed to.
However... after the relief and delay of having to bring our parts to 1334's shop, I was a little over eager to put thins back together. My question is... if the back cap of the motor falls off, is it recoverable by pushing it back in? If it appears to operate is it then fine? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Knocking the ball off: A viable and important strategy lost in the whims... | Brandon Holley | Rules/Strategy | 15 | 09-03-2008 16:15 |
| pic: 1726 guts | TheOtherGuy | Extra Discussion | 1 | 19-02-2008 01:15 |
| Knocking out Doubler Ball | mightywombat | Rules/Strategy | 47 | 23-02-2004 15:18 |
| Coupling the drill motor with out the 15 tooth gear | Chopper_Dave | Motors | 1 | 17-01-2004 01:06 |
| Knocking Down The Whole Stack... | Suike | Regional Competitions | 39 | 30-03-2003 19:33 |
Threaded Mode