cRio not detected...

[3195mentor]

Originally Posted by 1075guy

Have you set your team number in the driver station software?

From the laptop, can you ping 10.31.95.2 and get a response?

we did set the driver station, but i won't be able to test the ping until later this afternoon. would you mind writing out the next steps for both scenarios (being able to ping and not being able to ping x.x.x.2)?

thanks for the help!

[Racer26]

If you can ping, then your network is setup properly, and you should be able to see it. Similarly, if you can flash code into it, then this is working. There could still be an issue with a firewall or similar.

If you can't ping, its an issue with your network setup.

[3195mentor]

Originally Posted by 1075guy

If you can ping, then your network is setup properly, and you should be able to see it. Similarly, if you can flash code into it, then this is working. There could still be an issue with a firewall or similar.

If you can't ping, its an issue with your network setup.

we flashed the code directly to the cRio using a crossover cable.

[Racer26]

disable your wired adapter. the IP stack on windows boxes gets confused when it has two adapters on the same subnet

[3195mentor]

Originally Posted by 1075guy

disable your wired adapter. the IP stack on windows boxes gets confused when it has two adapters on the same subnet

So today i had my students take another look at all the documentation and wiring. one of the students found what the issue was almost immediately... apparently when i went to test the connectivity on the cRio myself, i had plugged the ethernet cable into port 2 instead of port one (D'OH!!)

thanks for the help though, i'm glad to know someone is looking out for us rookies (even when the mentor himself has a rookie moment)