|
|
|
 What's this about a robot that they speak of? Are we supposed to build one???? - ryan_f [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| What's this about a robot that they speak of? Are we supposed to build one???? - ryan_f [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
11-02-2010, 16:25
|
|||
|
|||
|
Re: LabVIEW project crashing
I am not getting any errors at all. That is my issue. This is the steps I take after adding the analog stuff.
Start driver station.exe Temp Deploy code (press play at the top) I probed some stuff to make sure it was working. It was. I pressed enable on the DS. All my probes then stopped working completely. I also did the same thing in the debug watching thing. (The light bulb). It stopped running after the 2nd loop, after clicking "Enable." All the little dot indicator things (dots that run along the steps) just stopped moving. I get no error messages and I am still able to stop the program (Clicking stop at the top) and re-do it all over again. So it is not the LabVIEW program itself. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vision Code crashing | flameout | Java | 1 | 26-01-2010 21:27 |
| DS crashing | ThisAintJeff | FRC Control System | 3 | 14-12-2009 14:48 |
| Help with Personal labview project | ZInventor | NI LabVIEW | 5 | 02-03-2009 09:00 |
| Crashing the Internet | MattK | Chit-Chat | 17 | 03-05-2003 12:28 |
| Max Crashing | SGK | 3D Animation and Competition | 11 | 02-02-2003 20:51 |
Threaded Mode