Mecanum Help Needed - Chief Delphi

FIRST is not about lowering the bar to those with the smallest expectations, but helping helping all teams exceed the standards set by the best. - Allison K [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Mecanum Help Needed

Thread Tools

Rate Thread

Display Modes

11-02-2010, 21:46

j.cole

Registered User

FRC #0379

Join Date: Jan 2010

Location: Girard

Posts: 159

Re: Mecanum Help Needed

Spoiler alert only go to this picture as a last resort it shows exactly the working holonomic drive (with a Logitech Dual Action Controller(you should only need to change the axes))
It is better to learn through testing and trying things out rather than copying. I repeat last resort only.

Attached Thumbnails

Click image for larger version

Name: Working Mecanum Drive.PNG
Views: 389
Size: 22.0 KB
ID: 8627

__________________

It's not normally a good idea to give a programmer a drill but rules are made to be broken.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mecanum Wheel Setup Help	Dylan5019	NI LabVIEW	16	10-02-2011 15:39
Mecanum help in labview.	Sam2197	NI LabVIEW	1	08-02-2010 18:59
Holonomic vs Mecanum Help!!	kSniper	Technical Discussion	10	25-03-2008 16:57
Mecanum Programming Help	Mars	Programming	8	27-02-2008 15:41
Mecanum Drive - Help	Smoking_Gun	Programming	22	04-12-2007 20:51

All times are GMT -5. The time now is 22:37.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.