|
|
|
 Build the wrong robot that aims well or build the right robot that can't aim.... decisions, decisions.... - Tom Bottiglieri [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Build the wrong robot that aims well or build the right robot that can't aim.... decisions, decisions.... - Tom Bottiglieri [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
12-02-2010, 07:43
|
|||||
|
|||||
|
Re: Communication issues
There's a known issue on a cold powerup. Sometimes the WGA takes longer to boot than the cRIO. If the cRIO finishes its network configuration before the WGA is ready to look for network activity, some routing information doesn't get set and the link to the robot doesn't get established. (There is not yet a software update to work around this.)
If this happens again, reset the cRIO only (there's a tiny reset button near the serial port) without removing power. The WGA will already be operating and the network configuration will succeed. If that doesn't fix it, you probably do have either an intermittent connection or a faulty WGA. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using non KOP router, possible cause of wireless communication issues? | saba | Programming | 10 | 31-01-2010 13:22 |
| team communication | Barak_BN | Rules/Strategy | 2 | 08-02-2009 13:20 |
| Communication devices | Daniel_LaFleur | General Forum | 3 | 05-01-2009 18:05 |
| 2 way IR communication? | neilcooper | Control System | 4 | 09-01-2008 20:14 |
| Section 2 - Communication | team222badbrad | General Forum | 2 | 08-01-2004 20:03 |
Threaded Mode