|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
legal pnuematic solenoid
what is the legal pnuematic soleniod this year, we did not get one in the kit of parts and we need to order a few. also what is the part number and where should we order them?
|
|
#2
|
|||||
|
|||||
|
Re: legal pnuematic solenoid
From <R72>
C. Solenoid valves. All such valves must have a maximum ⅛” NPT port diameter, and a maximum Cv of 0.32 (if non-KOP valves are used, the team will be required to provide part documentation validating that the valves meet these constraints). Solenoid valves that are rated for a maximum pressure that is less than 125psi rating mandated above are permitted, however if employed, an additional pressure relief valve must be added to the low pressure side of the main regulator. The additional relief valve must be set to a lower pressure than the maximum pressure rating for the solenoid valve. You should have received one double solenoid valve in the KOP |
|
#3
|
|||
|
|||
|
Re: legal pnuematic solenoid
we did not recieve the one in the KOP, and we missed teh deadline to get it replaced, so that is why I am wanting the serial number and other information to order new ones.
|
|
#4
|
|||||
|
|||||
|
Re: legal pnuematic solenoid
See the 2010 FIRST Robotics Competition Manual and Related Documents page on the FIRST web site. Under Section 10 - The Kit of Parts there is a link to Where to get more which includes a URL for FESTO's "FIRST robotics program" support page.
|
|
#5
|
||||
|
||||
|
Re: legal pnuematic solenoid
Rather than try to duplicate the KOP solenoid, just pick out a legal one that is available. We are using this one from SMC:
VQZ2120K-6G1-N7 This is a vqz2000 series valve with a metal seal, Cv is .3 in one direction, .32 in the other. Max pressure 145 PSI. It has 1/4" one touch fittings on the work ports, 1/8" NPTF on the pressure and exhaust ports and can be mounted on a manifold. It operates on 12 volts, and has lead wires attached to the coil (no plugs) The K indicates high pressure, or a 145 PSI rating. Finding this exact part may be a challenge, so look for one that is close. Ours is coming from Japan, with expediting, it takes a minimum of 10 days to get here |
|
#6
|
|||
|
|||
|
Re: legal pnuematic solenoid
thanks so much!
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Is it legal to have more than one acuator on one solenoid?" | fordchrist675 | General Forum | 7 | 09-02-2011 04:25 |
| Solenoid not firing off Solenoid Breakout | spooncwru | Pneumatics | 2 | 30-01-2010 17:46 |
| 2 SOLENOID BREAKOUTS? Legal? | BaByGrL | Pneumatics | 1 | 19-01-2010 14:04 |
| Pnuematic Question? | AlexD744 | Technical Discussion | 2 | 27-05-2009 22:42 |
| Pnuematic Claw | neoshaakti | Pneumatics | 4 | 21-01-2008 14:44 |