|
|
|
 Woodie once said he wanted to make our brains hurt. And I *don't* think he was talking about getting beaned by 198 grams of foam.... - Ken Patton [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Woodie once said he wanted to make our brains hurt. And I *don't* think he was talking about getting beaned by 198 grams of foam.... - Ken Patton [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
5 volt power for encoder
I am finally ready to make the connections to the encoders. Wondering if the Black Jag provides + 5 volts as shown in the drawing from the Getting Started Guideor if I need to provide the power.
Thanks Tony Sorry about the silly question. I pulled out my meter and measured 5 volts at the Jag. Last edited by TonyP : 12-02-2010 at 15:00. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| maximum rpm for encoder. | windell747 | Sensors | 6 | 31-01-2010 14:19 |
| encoder code for 18f8520 | cau.denny | General Forum | 2 | 17-03-2009 12:51 |
| Encoder for Crab Steering | Alphabet OJ | Programming | 4 | 09-02-2009 20:49 |
| Encoder reset on power up | darkorbit | C/C++ | 4 | 25-01-2009 10:06 |
| 12 volt Sensor Robot Power Supply? | BlackShadowFox | Electrical | 2 | 18-11-2007 14:06 |
Threaded Mode