|
|
|
 I was very concerned about this thread.
Then I realized you were talking about a computer. - Taylor [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I was very concerned about this thread.
Then I realized you were talking about a computer. - Taylor [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
12-02-2010, 14:38
|
|||||
|
|||||
|
Re: Bumper diameter compulsory?
I should have added that a hair dryer used to slightly heat the noodle that is flattened can allow it to reshape to it's former diameter.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 80 inch diameter? | Pneumaticsman | Technical Discussion | 4 | 15-01-2008 08:54 |
| [OCCRA]: diameter | mikaela50 | OCCRA Q&A | 1 | 28-09-2005 19:34 |
| Goal Diameter | Bremma | Technical Discussion | 2 | 13-01-2004 06:23 |
| Pipe Diameter | archiver | 2001 | 1 | 23-06-2002 23:45 |
Threaded Mode