Labview Solenoid Programming

3p1c w1n · #1 12-02-2010, 16:06

ok I set it to off when the case is false and error still pops up. I attached the error message.

Thanks for your help.

Alan Anderson · #2 12-02-2010, 16:14

Quote:

Originally Posted by 3p1c w1n

I attached the error message.

Don't try to build the broken project. Just click the "run" arrow and LabVIEW will be able to show you where it is broken.

3p1c w1n · #3 12-02-2010, 17:29

Thanks for the help
I haven't gotten that stuff working yet but I did get the compressor running

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Programming Double Solenoid?	Brandon_L	NI LabVIEW	13	14-02-2009 10:33
Solenoid Programming Issue.	Dr. Manhattan	Pneumatics	2	10-02-2009 17:42
solenoid programming	holty531	Programming	0	10-02-2008 16:17
Programming a Solenoid	Brigander	Pneumatics	4	17-02-2007 14:06
Solenoid Programming	duckshepherd	Pneumatics	1	17-02-2003 09:15