|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
||||||
|
||||||
|
Re: Motor declarations break analog module
Why did you choose to set the average bits to 30? By my calculations, you'll get a new value every 4 hours or so (if the FPGA even supports a value that large). A more reasonable value is 10, which will get you updates at about 50hz.
If you actually wanted it to average 30 samples, you should set the average bits to 5, since 2^5 is 32. Last edited by Joe Ross : 12-02-2010 at 23:16. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Open motor reference on Slot 6 DIO Module | trilogy2826 | NI LabVIEW | 2 | 27-01-2009 08:42 |
| spring break | thatphotochick | Chit-Chat | 6 | 29-03-2006 17:41 |
| Taking apart the motor control module | Adam Y. | FIRST Tech Challenge | 1 | 15-04-2005 14:02 |
| Module 7 gear -- fischer price motor | archiver | 2001 | 6 | 23-06-2002 22:55 |
| DC Motor current to an Analog Input | junkyarddawg | Motors | 43 | 04-04-2002 15:53 |