|
|
|
 REMEMBER - there ARE things more important than robots... false - Botwoon [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| REMEMBER - there ARE things more important than robots... false - Botwoon [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
13-02-2010, 02:26
|
|||
|
|||
|
Re: CAN Position control code?
The added voltage ran across my mind, but the potentiometer was mounted in some C channel since it was previously a throttle control for the 2008 robot. So there are physical stops that prevent it from going under .4 and over 2.8.
Also the the original poster, if you post what code you have currently, we could help you debug it better. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Position Control using potentiometer? | biojae | CAN | 13 | 03-02-2010 20:12 |
| More CAN control questions | Geek 2.0 | Electrical | 0 | 12-01-2010 13:40 |
| CAN control weirdness | nathanww | Electrical | 4 | 04-01-2010 21:13 |
| can we control the amount of air to control the speed of the cylinder? | Team2339 | Pneumatics | 22 | 11-02-2009 15:33 |
| Where can I find motor control in Camera.c? | sjung9442 | Programming | 3 | 31-01-2006 15:49 |
Threaded Mode