|
|
|
 IF WildstangIsAwesome = True and SkaIsAwesome
THEN
Act = AWESOME
End IF - Rohith Surampudi [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| IF WildstangIsAwesome = True and SkaIsAwesome
THEN
Act = AWESOME
End IF - Rohith Surampudi [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
13-02-2010, 09:18
|
|||
|
|||
Re: pressure problems
We had a chronic problem where we could only get 60 psi. Last night we found an allen head set screw in the (KOP) pressure regulator was leaking. It was not tight. A couple wraps of teflon tape and put it back in snug, and now we can get to full pressure. Hope you have the same simple solution, and it doesn't take two weeks to find it.
Last edited by ralfy : 13-02-2010 at 09:26. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does the Norgren Pressure Regulator show working pressure or stored pressure? | Madison | Pneumatics | 7 | 14-02-2008 17:40 |
| Labview problems and code problems | ajsetter | Programming | 25 | 18-01-2006 17:07 |
| Pressure physics problems | sanddrag | Math and Science | 8 | 01-07-2005 10:26 |
| Translating pressure sensor readout into actual pressure | Mercutio | Pneumatics | 0 | 13-02-2004 16:29 |
| Pressure Sensors | gthakore | General Forum | 14 | 12-01-2003 19:23 |
Threaded Mode