|
|
|
 It is proper to have a disagreement, but it is improper to be disrespectful. - Bill Moore [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It is proper to have a disagreement, but it is improper to be disrespectful. - Bill Moore [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
13-02-2010, 14:43
|
||||
|
||||
|
Re: Victor 884 PWM problem
If you tried both ways I would suggest looking into the pwm connecter part of the victor and then figuring out where the 3 pins should align in there because from trial and error I had I figured out that I had 2 pins in but not all three because of how big the hole for the connector was. Do you get it?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Victor 884 | Devo1098 | Electrical | 6 | 29-06-2007 07:51 |
| Victor 884 problem | Gal Longin | Control System | 11 | 26-01-2005 00:47 |
| Victor 884 problem | Gal Longin | Electrical | 11 | 26-01-2005 00:47 |
| Victor and PWM Cable Problem | RIgnazio | Electrical | 2 | 13-01-2005 23:02 |
| Victor 884 | Kevin Ray | General Forum | 25 | 28-01-2003 15:02 |
Threaded Mode