|
|
|
 Having someone with as much mainstream appeal as will.i.am is a great strategy to draw large amounts of attention to a program that has been relatively hidden to the masses. - Karthik [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Digital Input for Driver Station
I understand the Cypress card is for digital input into the driver station. I was going to use this to allow pre-selection of program to run during autonomous.
However, I was reading about the default driver station program and it allows you to simulate input if the Cypress card is not hooked up. Can we not just use this to select a program at the competition and not use the card? If you have more complex input needs, I could see where the card would be useful. But I just need a basic input and I think the simulation mode may work. Any ideas or thots why this would or would not work? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drivers station digital input trouble | finman | Electrical | 9 | 16-02-2009 08:06 |
| Driver Station Digital Input | Lord_Jeremy | FRC Control System | 2 | 09-02-2009 23:06 |
| Driver Station Input | SwampDogs | NI LabVIEW | 3 | 27-01-2009 11:33 |
| Flashing Driver Station Digital Input | MacGyver1718 | FRC Control System | 3 | 15-01-2009 19:22 |
| Interrupt on driver station digital input | Nameless | Programming | 9 | 04-12-2008 16:55 |
Threaded Mode